iPhone 7 Plus Rear Logo LED Flex Cable 16 Color Night Light
- This Logo is not battery consuming, but adopts the LED cold light resource
- This Logo does not need to be welded, only to replace the original one
- The brighter the screen, the shinier the Logo could become. (If the screen is in sleep mode, then the Logo is in sleep mode too)
- Upgrade version.16 color transformations, can be fixed as white light
- Package include: 1 x LED Logo For iPhone 7Plus
- Upgrade version: 16 color transformations, can be fixed as white light.
- Technolog: the LED cold light source, basic no electrity.
- Eorking priciple: LOGO is bright when the screen bright,but when lock screen,the LOGO will not bright.
- Changes with the brightness of the screen.
- This LOGO does not need to be welded only need to be more replace the original LOGO .
How to install:
1.Shutdown,teardown,remove the two screws at the bottom.
2.Suck the screen slowly with a suction cup.
3.Using a screwdriver,slowly open the screen.
2.Remove the battery,you need to be carefull when pull the battery.
3.Remove the original LOGO.
4.Install the lamp on the logo position.
5. Stick on insulating tape and sponge, the tape is across to stick and the sponge is vertical to stick.
6. Put the battery back to the original place, stick battery glue on the battery in order to prevent the battery inside is loose.
7.After installation of battery, adjust the screen to the brightest, Hold down interface and check the LOGO whether is work on, if not bright, you need to remobilize the interface.
8.Cover the back cover and fit the screws.
1 x LED Logo For iPhone 7Plus